2013 Bmw 328i

2013 BMW 328i, N20 engine. Timing chain guide assembly and oil pump drive chain failed catastrophically. Vehicle is available for inspection, however the authorized BMW dealership has already made clear they will accept no responsibility, and I would bear the expense of towing it two hours to their facility. The failure is a known issue with a class action case, but BMW took no responsibility, and falsified information stating the vehicle showed no signs of an issue when I brought my vehicle in for inspection. Eighteen months before failure, steam came from the engine compartment on a humid day, later connected to the water pump electrical connector recall. Following this, the vehicle ran consistently hotter than normal and lost noticeable power. Twelve months before failure, an intermittent oil pressure warning began triggering under load at highway speeds, particularly on inclines above 70mph. I brought the vehicle to Sandia BMW in Albuquerque, NM and reported all symptoms when I was contacted by them for the recall. The service advisor falsely claimed elevated operating temperature was optimal, suspected a faulty sensor, and returned the vehicle without offering further diagnosis or making me aware of the impending issue, all classic signs of the engine faults. Eight weeks later, the oil pressure light activated on a highway, followed immediately by a drivetrain malfunction warning, a violent grinding sound, and complete loss of power. The vehicle was towed and has not restarted since. I contacted BMW of North America's recall line. A case was opened and an advocate stated BMW would accept no responsibility because the class action was closed and I'mpast 70K miles. I raised the dealership's direct culpability. The advocate stated a dealership representative would contact me. No call was ever received. This failure is consistent with BMW Service Bulletin SI B11 03 17. A engine safety recall is warranted regardless of age to protect the public.

The contact owns a 2013 BMW 328I. The contact stated that while driving at an undisclosed speed, an unknown warning light illuminated. The vehicle was taken to the dealer, where it was diagnosed with a hole on top of the fuel tank. The contact was informed that the fuel tank needed to be replaced. In addition, the contact was informed that the failure was a known failure with the vehicle. The contact stated that the manufacturer had previously initiated an extended warranty coverage for similar vehicles; however, the repair was not covered under the Extended Warranty. The manufacturer was made aware of the failure but provided no assistance. The failure mileage was approximately 56,910.

The contact owns a 2013 BMW 328i. The contact stated that while driving at an undisclosed speed, the engine overheated, and multiple warning lights were illuminated. The contact then stated that the vehicle lost power and would not restart. The vehicle was towed to an independent mechanic, where it was diagnosed that the water pump and electrical plug connector had failed and needed to be replaced. The vehicle was repaired. The contact later received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The vehicle was taken to the dealer, where it was not diagnosed or repaired. The contact requested reimbursement for the cost of the repair that was performed prior to the safety recall, but the dealer informed the contact that the reimbursement claim was denied. The manufacturer was made aware of the failure, and the manufacturer also denied the reimbursement claim. The approximate failure mileage was 89,565.

See attached document for complaint. I am writing in reference to the recall on my 2013 BMW-328xi. The vin number is. The recall is for the water pump electrical connector. My water pump failed May 2024. I went to an independent repair service center that specializes in BMW repair, which in turn was the closest service center to where the vehicle broke down. I paid out of pocket for the repair. Now there is a recall on this part, I would appreciate reimbursement for the charges. I am enclosing a copy of the invoice.

Passenger Restraint system malfunction for the front passenger seat. This may not trigger the airbag for a passenger sitting in the front if a collision occurs and can seriously injure someone. This problem appears to be very common with BMW models within this timeframe. All over car forums and youtube videos, some videos with over 100k views per video. I am not sure how BMW has not recalled this safety issue as it seems to linger throughout many of their models for many years. As soon as the malfuction occured\, the warning sign and lamp lights did flash on.

The contact owns a 2013 BMW 328I. The contact’s daughter stated that while driving at an undisclosed speed, there was smoke coming from the engine compartment. There was no warning light illuminated. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); and the vehicle was taken to the dealer to have the water pump replaced. The contact was informed by the dealer after the repaired that the valve cover gasket had failed and needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 123,000.

See attached document for complaint.

Recall was issued in August 2024 and there is yet to be a fix/remedy

MY 2013 BMW 328 NON TURBO experienced an all of a sudden warning that the temperature was high even though the temp gauge did not show. Car was pulled over and towed to repair shop. Broken VANOS bolts were discovered and car made a load noise when run.

Dropped off my BMW on June 17 for a water pump recall 24V-608 for wiring harness connector issue and the dealer did indeed discover corrosion and damage to the water pump which could cause a thermal event or a fire. However, they repaired 1 single strand of wire by replacing a pin and not the entire connector or the water pump. Furthermore, I was charged $197 for that damaged wire saying even though the wire was corroded, I had to pay to repair that to do the recall which was to put a plastic sheath over the wiring.

The contact owns a 2013 BMW 328I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

Fuel leak from factory fuel pump housing

The contact owns a 2013 BMW 328i. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); However, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

The contact owns a 2013 BMW 328I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2013 BMW 328I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

It has been over a year since I received the first recall notice for my vehicle, and I am continuing to receive notices from BMW that state there is no remedy available. This recall has the potential to create premature depreciating damage to my financial asset as well as serious safety risks myself and my family. I would like to know what kind of alternative remedy BMW has to offer me, since no repair has been offered in a timely manner.

BMW has not provided a timely solution for the latest recall dated 8/2024.

The contact owns a 2013 BMW 328I. The contact stated that while driving at an undisclosed speed, the check engine warning light illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the water pump and water pump connector. The contact was advised to discontinue driving the vehicle. The vehicle was not repaired. After investigating the failure, the contact related the failure to NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); the VIN was included, but parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. The failure mileage was 201,000. VIN tool confirms parts not available.

Dear NHTSA, I am submitting this complaint regarding a serious safety issue with my [Your BMW Model & Year]. My vehicle was recalled due to an issue with the engine coolant pump, which could lead to a short circuit and, in rare cases, a fire. •The recall was issued over a month ago, but BMW has not provided a solution or a repair date. •On March 26th, 2025, I visited an authorized BMW service center for an oil change and to address the recall, but they informed me that the necessary parts were not available and gave no timeline for the repair. •For the past three weeks, white smoke has been coming from the hood, and there is a noticeable burning smell. •I have a video documenting this issue. •My vehicle is in active use, and the problem is getting worse daily, increasing the risk of engine failure or fire. BMW’s delay in addressing this recall is putting my safety and the safety of others at risk. I request immediate action to ensure that BMW prioritizes this repair and prevents further damage to my vehicle. I would appreciate your urgent attention to this matter. Please let me know how I can proceed with this complaint. Best regards, Name: [XXX] Phone: [XXX] Vin Number : [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The vehicle's manufacturer (BMW) has failed to remedy a potentially lethal safety recall in a timely manner.