2015 Chrysler 200

The vehicle has suffered a total failure of the passenger seat jumper wiring harness, which has completely deactivated the entire Supplemental Restraint System (SRS / Airbag system) and triggered the airbag warning light. This is a known manufacturing defect covered under an active Technical Service Bulletin (TSB). ​A certified Chrysler dealership previously performed a paid repair for this exact TSB defect, meaning the replacement safety component has failed prematurely. The vehicle is currently an active safety hazard on the road, as no airbags will deploy in an accident. Chrysler Corporate has refused to remedy this failed safety system, leaving the vehicle completely unprotected.

While driving my 2015 Chrysler 200, the vehicle randomly shifts into neutral without the driver initiating any gear change. Prior to this occurring, all dashboard warning lights illuminate simultaneously and the odometer display starts blinking so many lights — these appear to be warning signs of an electrical failure that then causes the transmission to shift into neutral while driving and sometimes even not able to shift gears. This has occurred multiple times at normal road speeds and causes sudden loss of power and vehicle control, creating a serious safety hazard. The vehicle was taken to an independent repair shop who confirmed it was an electrical issue beyond their capability. It was then taken to a Chrysler dealership who charged $250 per hour for diagnostics, kept the vehicle for a full day, and was unable to identify the cause. Their only suggestion was an aftermarket radio installed by a prior owner — however an aftermarket radio would not cause all dashboard lights to activate and the transmission to shift into neutral while driving. I contacted Chrysler corporate (Case #97099954) who confirmed no open recalls exist and refused to cover the repair stating the warranty has expired. However this is not a wear and tear issue — this is a safety defect. The sequence of all warning lights activating followed by the transmission shifting to neutral points to a failure in the vehicle electrical control system, possibly the TIPM or Transmission Control Module — both known problem areas on this model. This is a serious safety defect and I am requesting NHTSA investigate this issue on the 2015 Chrysler 200.

I was on

I took my vehicle in for service because cylinder 6 had a misfire and the dealership told me that the Catalytic Converter failed internally and stated it can happen at anytime and it sends metal into the engine causing damage.

My airbag light on the driver side is on. Isn't this a recall part

Airbags deployed 15 seconds after impact. Passenger airbag deployed from the top of the dash and hit the windshield causing the windshield to shatter.

I honestly believe this has to do with me being discriminated by people even emergency dispatch and police from the city of Inglewood , this is not the first time my car gets tampered with, but to start I already had felt something was off with the vehicle because I was parked and it accelerated all of a sudden last night of 03/24/26 then today on 03/25/26 i was on the freeway on my way to work then I felt something wasnt how the last time I drove it then it accelerated all of sudden and some setting on my car where changed so I returned home I didn’t want to risk my life or anybody else’s so i took pictures of the miles 114199 and how the cars is in case someone tries to take it and cause and incident & tries to cause and organized crime so I can get into trouble

The contact's son owns a 2015 Chrysler 200. The contact stated that while his son was driving at an undisclosed speed, the transmission unexpectedly shifted to neutral (N). The message "Please Place Vehicle in Gear" was displayed. The contact's son was able to drive the vehicle after shifting to drive(D). The vehicle was taken to an independent mechanic, but no cause for the failure was found. The vehicle was not repaired. The mechanic related the failure to NHTSA Campaign Number: 16V529000 (Power Train); however, the VIN was not included in the recall. The manufacturer was made aware of the failure, but informed the contact that there was no recall associated with the VIN. The failure mileage was unknown.

It shuts down the engine or. Does not go in park it has something going on with electrical I can not afford it help please

The contact owns a 2015 Chrysler 200. The contact stated that while driving at an undisclosed speed, the driver’s side headlight failed to function as intended. The message "Headlight not Working" was displayed. The vehicle was taken to an independent mechanic; however, no cause for the failure was found. The driver’s side headlight was replaced; however, several days later, while driving at an undisclosed speed, the passenger’s side headlight failed to function as intended. The vehicle was taken to an independent mechanic. However, no cause for the failure was found. On a separate occasion, while driving at an undisclosed speed, the transmission failed to shift as needed. While the shift button was moved to reverse(R), the reverse(R) light failed to illuminate, and an abnormal dinging sound was coming from the vehicle. The message "Transmission Issues" was displayed on the instrument panel. The vehicle failed to move while in reverse. The contact stated that the failure was predominant during cold weather. The vehicle was taken to the dealer, where it was diagnosed, and determined that the transmission sensor clusters had failed. The dealer reprogrammed the Powertrain Control Module and the Transmission Control Module. However, the failure persisted. The contact associated the failure with NHTSA Campaign Number: 16V529000 (POWER TRAIN); however, the VIN was not included. The manufacturer was made aware of the failure. The failure mileage was approximately 120,000.

I’m not sure but it will randomly die and have to be restarted there are times it does it more than others but every time is extremely dangerous because you essentially lose control of the car until it is restarted and it shift extremely hard sometimes like it feels like the transmission is going to fall out it jerks the entire car violently and there are numerous low voltage codes as well

Airbag light is on , 2nd time my lower control arms are broken and I go through a battery every 2 years average

The contact owns a 2015 Chrysler 200. The contact stated that while driving on several occasions at various speeds, the vehicle stalled. The power steering and battery warning lights were illuminated. The vehicle was restarted each time, but the vehicle took a progressively longer time to restart. Eventually, the vehicle failed to restart and was towed to an independent mechanic, where it was diagnosed and determined that the battery needed to be replaced. The vehicle was repaired, but the failure returned five minutes after driving off the lot. The vehicle was taken back, and it was determined that the wiring and electrical system had a communication fault, and that the vehicle needed to be taken to a dealer to be reprogrammed. The vehicle was towed to a dealer, where it was diagnosed, and it was determined that the battery cable and harness needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 70,000.

You have a recall for chryslr 200 2015 for intermittent starting and stalling caused by faulty PDC connector. NHTSA. My car is doing exactly that but its not under the recall why not? It had done this gor the last 4 months

The transmission is stuck in 3rd gear and sometimes don't move at all. It has jumped in neutral a couple of times while driving or automatically goes to paddle shifting without touching the gear control. It is basically undrivable with only 95000, or so miles.

The contact owns a 2015 Chrysler 200. The contact stated that after the vehicle was started and shifted to park(P), the vehicle unexpectedly shifted into neutral(N), and the air bag warning light illuminated. The contact attempted to shift the gear selector into reverse; however, the vehicle remained in neutral. The contact stated that the vehicle could not be turned off. The contact disconnected the battery to turn off the vehicle. The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The approximate failure mileage was 138,000.

The contact owns a 2015 Chrysler 200. The contact stated that the vehicle failed to start. The engine warning light was illuminated prior to the failure. The failure persisted over time. The vehicle was taken to an independent mechanic who determined that the failure was related to the cruise control, transmission, and fuel pump. The local dealer was contacted, but the vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 180,000.

While driving at approximately 60 MPH on a highway, the vehicle suddenly lost motive power, stalled, and entered "limp mode," shifting into neutral or a low gear unexpectedly. This failure caused a rapid deceleration in high-speed traffic, effectively disabling the vehicle and creating an immediate safety hazard and risk of collision. The engine stalled completely, requiring the vehicle to be coasted to the emergency shoulder. After a key cycle, the vehicle restarted but the check engine light remained illuminated. Independent diagnostic scanning retrieved Diagnostic Trouble Codes (DTC) U0018 (Medium Speed CAN Communication Bus Short) and P0894 (Transmission Component Slipping). These specific codes and symptoms (intermittent electrical short causing stall/shift-to-neutral) are identical to the safety defects addressed in NHTSA Recall 15V-470 (FCA Recall R24 - Power Distribution Center Electrical Connector) and NHTSA 16V-529 (FCA Recall S55 - Transaxle Wiring Harness). Although records indicate Recall R24 was marked as "completed" on this vehicle in July 2015, the specific safety defect has recurred, presenting the exact same failure mode. The Authorized Dealer was contacted regarding the recurrence of this safety defect but refused to perform a no-charge inspection, citing an expired repair warranty. The Manufacturer (FCA US LLC) was also contacted to report the recurring safety failure but refused to open a case or authorize a diagnostic inspection, despite the life-threatening nature of the defect. The component and vehicle are available for inspection. The failure has not been resolved.

I put the car in park, once I released the brake the car started jerking forward. While this was going on, the dash displayed powertrain failure. I was only able to get it to stop by turning off the car. When I turned the car on following the event, I had a check engine code: P1B13-00 "Park-By-Wire-Unintended Out of Park Position". Since that incident, the car has excessive forward roll when putting the car in park. The shifting has become unpredictable and rough, it also gets stuck in 4th gear often. I took my car to a Chrysler dealership to see if it was in recall R08 / NHTSA 15V-090, I was told it was not and that I would have to pay for them to inspect it. My car was manufactured just before the recall window.

transmission service (power train ) caused my parking rod dislodged/broken to slip/jerk to lose control of vehicle. It had put us at high risk, no airbags didn't go off to causing passenger to hit their head blacking out and non-stop pain in rotating cuff of right shoulder. It was inspect by the police and city from not being drive-able to be towed and inspected by the towing/mechanical person. The messages that showed on dashboard was transmission failed/ services, engine light and having electrical issues to light was flicking once press on brakes. when idling to pulling off from a stop cause to jerk.