2016 Acura Mdx

2016 Acura MDX. The red LED section of the inner tailgate taillight (lid light) has failed and no longer illuminates. The white backup bulb in the same assembly still works. The LED section is sealed inside the assembly and cannot be serviced, so the entire lid light must be replaced. This vehicle received safety recall M49 (NHTSA 19V-256) in 2019 for moisture intrusion into the inner taillights. The same failure has now occurred again. Honda's own Part 573 report for recall FLI (NHTSA 25V-259) states that the redesigned assemblies installed under 19V-256 do not sufficiently prevent moisture intrusion, and that moisture entered through two new pathways: between the gasket and the seal ribs of the lid light, and at the interface between the gasket and the body dust sealer. My failure appears to be exactly that condition. The NHTSA VIN lookup shows zero unrepaired recalls for this VIN. When I contacted Acura, I was told the issue was repaired in 2019. That response addresses M49, not FLI. I have not been able to get confirmation of whether FLI applies to this VIN or was ever performed. Loss of the rear position lights reduces visibility and is a citable equipment violation.

On August 3rd the vehicle began making a loud clicking/knocking noise from the engine area of the car. Took the car to Richard Bailey Automotive on August 4th for diagnosis. Was informed a week later the engine needed replacement. Have owned the car for 3 months. No warning lights except to clean the backup camera. All maintenance has been performed on the vehicle.

The engine in the car caught fire and subsequently destroyed the vehicle. The car was parking in a shopping center parking lot at the time.

The contact owns a 2016 Acura MDX. The contact stated that while driving at an undisclosed speed, several unknown warning lights illuminated. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The dealer was not made aware of the failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 133,000.

I received a letter from Acura about a safety recall on the subframe. My car has been making a creaking noise and so I called the number on the letter. The guy gave me the number to Acura, Brookfield WI. I called and talked to someone there today, I think his name was John. I told him I wanted my car checked for the recall issue and I am worried about the noise. He said a subframe won't cause squeaking and I would have to pay $200 for them to look at it. I said I would call back in fall as the letter states but Im still wanting this issue fixed now.

The contact called on behalf of the owner of a 2016 Acura MDX. The contact stated that the owner reported an abnormal knocking sound coming from the engine while starting the vehicle. No warning light was illuminated. The vehicle was towed to the independent mechanic, where the timing belt tensioner was replaced; however, the failure persisted. The mechanic disassembled the oil filter and discovered metal shavings inside the filter. The mechanic related the failure to NHTSA Action Number: PE25008 (Engine). The manufacturer was notified of the failure; however, no assistance was provided because the VIN was not included in NHTSA Campaign Number: 23V751000 (Engine and Engine Cooling). The vehicle was not repaired. The failure mileage was approximately 60,000.

The contact owns a 2016 Acura MDX. The contact stated that while the vehicle was parked and attempting to open the trunk, the contact became aware that the inner driver’s side taillight was inoperable. The contact associated the failure with NHTSA Campaign Number: 19V256000 (Exterior Lighting); however, the VIN was not included. The vehicle was taken to an independent mechanic. The independent mechanic stated that the taillight needed to be replaced. The vehicle was not repaired. The dealer was not contacted. The manufacturer was not made aware of the failure. The failure mileage was approximately 149,000.

Catastrophic Engine failure. Engine shook, then loss power. Multiple lights went off. Repair shop found metal shavings in the oil pan. Later diagnosed by specialist with cam/rocker engine issue. Recommended action was engine replacement.

I just got back home from Walmart, went in my house to get a few things and head to my camper. I had to get one last thing ,so I started to drive over town I noticed a plastic burning smell ,I thought someone was burning trash, so I keep going ,the smell got worse,so I stopped and was going to check what it was and smoke started coming out of the vents,so I turned around drove car home,as I was pulling into my drive ,I noticed the wiring harness fell from behind glove box ,on fire on the floor. We got car in driveway and got out,tried to extinguish the fire but couldn't, so grab everything out of the car,and the car became totally engulfed in flames,the car was totally gone from this electrical short.

Engine began knocking, brass colored shaving in drained oil due to bearing damage. This vin is not covered by the recall scope

I am filing a safety and compliance complaint regarding execution of Federal Recall Campaign #26V365 by Valley Stream Acura and sales fraud by Paragon Acura. I purchased this 2016 Acura MDX from Paragon Acura on May 29, 2026. I have driven it only 550 miles, placing it strictly within the statutory New York State 60-Day Used Car Lemon Law Warranty window. A certified 6-page independent ASE forensic report documents that Valley Stream Acura bolted the federal recall brackets directly onto severely cracked rear control arms and rusted struts without disclosure. Furthermore, Paragon Acura forced a brand-new front control arm link onto a deeply pitted, scaling, and structurally compromised front steering knuckle to mask pre-sale defects, signing a false NYS highway safety certification. The vehicle was released to me with a bone-dry, empty engine cooling loop, creating an immediate fire hazard. Acura Corporate (Case #16437213) refuses to issue a corrective directive, willfully leaving a non-compliant vehicle on public roads.

Started (first noticed)check engine light flashing turned radio down right of way and noticed engine knocking with no warning still 40% engine oil life left. Had test done P0303 misfire on cylinder 3 and rod bearing knock was told need an engine . Had all oil changes and maintenance done on time. ran my vin and unfortunately was told it is not covered under recall.

My 2016 Acura Max sha awd has 124 k on it and the other day I was driving down the road and my engine light went on than I lost power down to 20 mph and heard a knocking noise from the engine like the rod bearing broke or something I’ve noticed the recall on the engine for some Acura 2016-2025 3.5v6 engines but Acura is saying my model car was not in the recall list which I can’t understand why if it has the same engine 3.5 v6 with the same rod barring issue as the ones on the list being recalled . The issue is with all 2016-2025 Acura Mdx models that have the 3.5 v6 in it .

I was driving on the highway. All of a sudden, my engine started making knocking noises. Shortly after that, the car started to lose power, and immediately the low engine oil light came on. I pulled over immediately to check the engine oil level. Oil level was normal. I restarted the car, but the mechanical knocking noise was evident and did not sound right. Towed the car to the closest Acura Dealership. Diagnostics states that engine has ceased and would not crank. Replacements engine is required and would costs approx. $4200. Acura has a recall on some 2016-2020 MDX for similar engine issues, but my VIN did not qualified. The symptoms i exprienced is very similar to what was described in the recall. Acura representative denied any goodwill support/help.

Our 2016 Acura MDX SH-AWD has the exact same engine problem/damage caused by the Connecting Rod Bearing recall. Our vehicle displayed the exact symptoms described by countless other MDX owners including owners who have vehicles both on & not included on the current recall list.

I started the vehicle and steering wheel was frozen and EPS, Brake, and lane departure lights on the dash. I shut the car off and let it sit for five minutes. Restarted and the steering wheel came back to normal. but all light remained on. I drove the car about half a mile and the lights went off. When I got home, I shut the car off and started it again. The wheel was frozen again, and all the lights came back on. I shut the car off and re-started and steering came back on. I'm afraid this will happen again but while I'm driving. I looked up the issue but no recall but a lot of complaints with same problem. I cannot drive like this for it can be dangerous if I'm driving and lose control of the vehicle and hurt someone or myself. I took the car to a mechanic, but he said there is no current issues just stored codes. Today I had the same problem.

This make and model has the same problems with the engine rod bearings it’s the v6 3.5L

FOUND #4 CYLINDER MISFIRE - METAL CONTAMINATION SPUN A BEARING INTERNALLY INSIDE THE ENGINE. RECOMMEND REPLACING THE ENGINE. SEE QUOTES BELOW: RECOMMEND AT THE SAME TIME AS THE ENGINE REPLACEMENT - STARTER, TIMING BELT, SPARK PLUGS, AND VALVE. Found #4 cylinder misfire – metal contamination – spun a bearing internally inside the engine. Recommend replacing the engine.” After researching this issue, I became concerned that this failure appears very similar to the widely reported connecting rod bearing failures associated with Acura/Honda 3.5L V6 engines and Recall 23V-751. The symptoms in my vehicle closely match the issues described in the recall and related investigations, including: connecting rod bearing failure, spun bearing, internal engine damage, metal contamination, cylinder misfire, and complete engine failure. Additionally, I understand that the National Highway Traffic Safety Administration (NHTSA) has expanded investigations into similar engine failures affecting Acura and Honda vehicles outside the original recall VIN population.

The contact owns a 2016 Acura MDX. The contact stated while driving at an undisclosed speed, the transmission independently shifted into neutral. The vehicle was driven to the shoulder of the road. The contact stated that several unknown warning lights were illuminated. The contact stated that the event was scary. The contact stated that the vehicle was so hot inside. The contact crawled to the passenger's seat and exited the vehicle. The vehicle was towed to an independent mechanic where it was diagnosed with a failed engine. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The vehicle was towed to the dealer, however the vehicle was not inspected. The contact was informed that the repair was not covered under any unknown recall. The manufacturer was made aware of the failure. The contact was informed that the repair was covered under an unknown recall which had a similar failure description. The contact was advised to take the vehicle to the dealer. The failure mileage was approximately 150,000.

When driving at highway speeds there randomly is a full loss of engine power for 3 to 5 seconds. Each time this has occurred I was on the highway and depressing the gas pedal further to either pass another car or because I'm driving up and incline. For several seconds the car looses all power and begins slowing. Traffic approaching rom behind may have to apply brakes. I am unsure whether it's the transmission disconnecting from the engine, or the engine dropping to idle speed, I have tried pressing the gas pedal further and also tried the paddle shifters to force a downshift, and neither has any effect. I have been to the dealer multiple times and they can't re-create the issue so they dismiss it.